Ducati.org forum banner

Pit-bull rear stand pin size and front stand poll

2K views 2 replies 3 participants last post by  LAH78 
#1 · (Edited)
So I can finish my tear down and track build I need a new pin for my rear stand, pit-bull advertises 2 for the 1098. 43 and 41mm. Do I need one for each side?

Also what front stand are you guys using? :rlwhore:
forget about that i just notice the conversation about front stands.
I need to pull the forks off and check them since I think I compressed them too much during transport. I had fork oil all the way to the floor.

Also is there a lower triple replacement that will allow me to use my 848 front stand?

Ok I'm going back to watching the snow fall
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top