Ducati.org forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
632 Posts
Same as Bob says, if you have a closed cover with gasket, then Bleed as Com says.

If you do have an open cover, pull the cover, pressure plate etc, remove each plate, clean the steels remove the rust & lightly lube each steel with white lithium spray grease wiping most off but not all, if you over do it it may slip, but you would have to go crazy with it.
Then reassemble once all cleaned and lubed.

I do this every 3 months or as required to avoid the grabby graunchying noise they can make when hot and dry.

Craig
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top