Ducati.org forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
8,735 Posts
No, but I have about 90% of them sitting on my workbench right now since I parted it out :D
 

·
Registered
Joined
·
96 Posts
Discussion Starter · #6 ·
No, but I have about 90% of them sitting on my workbench right now since I parted it out :D
Good! just measure every one and compile it all into an excel spread sheet. It should not take long. Here I'll give you column headings
Bolt Location On bike
Bolt length
Thread size
Metric or SAE
Head size
Drive type <hex torque etc..)

I'll check back in a few hours LOL
Actually a photo of each on and off bike would be nice plus torque settings and if locktite or greased LOL
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top