Ducati.org forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
I was pulling the coil packs off to replace my plugs. One of the rubber boots on the bottom broke and is now stuck inside the horizontal cylinder head.



Any tips on how to remove that? There's not much room for tools and there is no room to try and grab it with even the smallest needle nose pliers I have.



Searched on here and for videos and can't find anything. Just another part I have to order now.
 

·
Registered
Joined
·
7 Posts
I just overcame the same problem. I used a right angle pick to get it out just remember to blow out any residue before you remove the plug.
 

·
Registered
Joined
·
6,165 Posts
Always always always run a bead of gasoline, white petroleum Grease or dialectic grease into the end of that rubber plug tube seal when changing plugs or refitting coils. So the boot don’t stick..

90* seal pick, top of an old style car aerial bent 90*.. long needle nose pliers if you have room.
 
1 - 3 of 3 Posts
Top