Ducati.org forum banner
1 - 3 of 3 Posts

· Registered
134 Posts
Discussion Starter · #1 ·
If I'm looking to swap in cams from a 996SPS to a 996S, will the SPS' cam fit into the key slot on the 996S' camshaft pulleys?

If so, will the timing marks on the pulley and the cylinder head still be right and correct after the cam swap?

Assume I'm using stock non-adjustable cam pulleys.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.