Ducati.org forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
378 Posts
I purchased a set of the NRC lights, and a set of connectors, soldered them together, applied heat shink, and they came out nice. Used these for a couple of weeks with a set of Driven bar end mirrors which work better than the stock mirrors, and are high quality billet.

Turn signals blink the normal sped for the first blink or two, then they go into a faster blinking mode, which I didn't think was any issue.

Visibility is excellent, very yellow.

However, I re-installed the stock mirrors as a little bit of the paint was blemished where the stock mirrors were mounted, which were not completely covered up by the NRC flush turn signals.

PM me if interested... or get them from Citta Corsa if you want to splice in a resistor and do your own soldering.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top