Ducati.org forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Just bought a running 98 ST2 and had it certified. During certification, all lights worked but it was never started. Wheeled it off the trailer at home and tried a start...didn't have enough in battery to start it. Wheeled it into garage and tried to start again, slow turn..no start. Tried again in 5 minutes....nothing...no gauges, no lights, no horn, no cranking, nothing at all!

Charged the battery and attempted to hook up battery and had arcing and engine tried to turn over. Attached ground and hooked up multi meter between battery and positive lead. This showed me voltage flow. Keys were NOT in the bike! Disconnected the start switch and key ignition...still showing voltage flow.

Any thoughts??
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top