I have a 2015 white 821, 2k miles and already got my first service done around 700 miles. I left my bike outside today in 80-90degree heat in the shade and with a cover on. I came back to the bike about 7 hours later and started it up, within 5 minutes the engine light came on with a warning hazard indicator next to the riding mode. I turned it off and turned it back on. Same problem. I called the dealer they said to try to ride it out. After riding for a couple minutes the red warning lights went on and the bike wouldn't go above 30 MPH. I was full throttle and the bike didn't respond. It was basically in limp mode. I pulled over again started the bike up 15 minutes later and then it ran as normal...could this be an issue because of a heat sensor or throttle assembly issue? HELP. Going to call the dealer again tomorrow. Hope it doesn't happen again.