[Troy T8]

so im installing a full system while running the bazzaz zfitc. i pulled the o2 sensors and get the exhaust holes, but where the o2 sensor plugs into the electrical, i dont know if something needs to be plugged in. i heard the termis come with plugs for the servo and o2? is this just a cover or do i need an o2 eliminator? or will it not matter once its mapped?

 

[cbr6]

you should have received o2 eliminators with the zfi, did you purchase it new ?

 

[Troy T8]

no got it off the forum

 

[CorseRob]

I actually cut the end off the O2 sensor, took out the connector bits and sealed it with gasket maker...let it dry and plugged it into the harness as a cap of sorts.

I flashed my ECU with JPdiag and disabled the O2 sensors that way...no lights and it seems to run great to me.

 

[Troy T8]

but im not getting any error codes because i have dp ecu. the question now is does the bazzaz pull info from the eliminator or can i just leave in unplugged because nothing is looking for it?

 

[CorseRob]

Sorry, I misunderstood, I did that just so I didn't have exposed electrical...not familiar with Bazzaz so cant offer anything on that.

 

[cbr6]

but im not getting any error codes because i have dp ecu. the question now is does the bazzaz pull info from the eliminator or can i just leave in unplugged because nothing is looking for it?

Not sure, But I believe the DP ecu turns off o2, if so you're probably ok. Check with bazzaz, the have very good costumer service.