Ducati.org forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
328 Posts
rapidrobin said:
Hi Jeff, I have had stands made for my 1098. The normal front stand works fine below the forks. The rear axle bore is 43mm so I had a stand made with a 42 X 200 shaft and this works perfectly. I used 2 sealed bearings in the shaft housing on the stand and I can run the bike at idle in first gear to lube the chain etc. Hope this helps, let me know if you want some pics. Robin
Could you post them here please? I would like to make some as well.

thanx.

CAG
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top