Ducati.org forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
374 Posts
Discussion Starter · #1 · (Edited)
So I powder coated my swingarm. I put aside the bearings and spacers, but they got knocked over and mixed up. Anyway, the right side of the swingarm has 2 different spacers: numbers #s 9 and 12. Which one is the inner and which one is the outer? One is wider and has bigger lip and other one small with a tiny lip. The schematic is not helpful. Can someone please look on their 848/1098/1198 just to be sure.


Thanks
 

Attachments

·
Registered
Joined
·
529 Posts
These pics are from an extra 2009 848 swingarm that I have on the shelf, and the spacer shown here is inside spacer #9. The spacer measures 12.36mm total, and the lip (on the left as looking at the pictures below), is about 5 mm; good luck...




.
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top