Ducati.org forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I have a 2000 ST2 and have to do a complete throttle body setup from scratch. My Mathesis tool connects fine to the TPS but not to the diagnostic port.

What software have people used to communicate with this ECU? Alternately, is there a way to do the setup without the Mathesis tool?

So far I have the TPS set at 150 millivolts but need to set the vertical throttle body’s throttle plate at 2.4 degrees and I’m not sure how to go about that as the next step.

Thank you.


Sent from my iPhone using Tapatalk
 
1 - 1 of 1 Posts
Top