Ducati.org forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
322 Posts
Discussion Starter · #1 · (Edited)
So I can finish my tear down and track build I need a new pin for my rear stand, pit-bull advertises 2 for the 1098. 43 and 41mm. Do I need one for each side?

Also what front stand are you guys using? :rlwhore:
forget about that i just notice the conversation about front stands.
I need to pull the forks off and check them since I think I compressed them too much during transport. I had fork oil all the way to the floor.

Also is there a lower triple replacement that will allow me to use my 848 front stand?

Ok I'm going back to watching the snow fall
 

·
Registered
Joined
·
58 Posts
I have a Pit Bull rear stand with the 41mm pin for the left side. The 43mm is for the right side. For the front, I'm using a Pit Bull too from my Gixxer I use to own, it fits.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top