Ducati.org forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have installed a double bubble screen on my ducati monster 796 but cannot get the nuts on the bottom two screws. I think I might have to remove the small fairing, but am not too confident about doing that.Any help would be gratefully received.
ayjaydubya:blind:
 

·
Registered
Joined
·
12,933 Posts
Find a long pair of needle nose pliers. Can't remember exactly what they are called but they are generally approx. 1' long and can be purchased at Home Depot, Rona, Home Hardware. We have to use this type of tool on the bottom 2 nuts on the 848 screen as they are in a very awkward spot up under the nose.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks [email protected],
I can't even get my fingers in to put the nuts on the screws, and there is no room to get pliers in and I'm not even able to see the end of the screws. I think I shall have to remove the fairing.
Regards ayjaydubya
 
1 - 3 of 3 Posts
Top