Ducati.org forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hello all, I have searched and googled with no luck. Any help is appreciated.

I have the Rizoma Rear hub axle slider for the Panigale and I have the Pitbull front and rear stands. The rear pin was swapped out to a 30mm pin to fit nicely into the Rizoma rear slider.
BUT I feel like the bike is unstable on the rear stand because of the added few inches from the slider. It almost looks off center when looking at it from the rear. Lets say if the pin was 5 inches in length which was supposed to go all the way into the axle. Now 2 inches are in the rizoma and the rest of the 3 inches are in the actual bike. Am I making sense?

Any input? or anyone have the same setup?

I just don't feel comfortable leaving the bike on it how I used to.

Thanks
 
1 - 1 of 1 Posts
Top