Ducati.org forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I have a silly question. Upon putting my bike back together and re installing my tail light, i have been having trouble plugging it back in. Is this the correct plug for the tail light? Does it require a lot of force to put back in? Honestly, i was afraid to ask anyone because out of everything i put back on, this is the only thing giving me problems. Its a ducati 999 bip.
 

·
Registered
Joined
·
37 Posts
The fit should be snug but never forced. Unplug and make sure none of the pins are bent or recessed. I'm not familiar with the 999 but am experienced with general electronics. I'm a former aviation electrician.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #4 ·
They do not appear to be bent. But that could be due to the angle at which im viewing the plug. They are definitely not recessed though. The plug is welded to one of the head pipes with plastic. Would it be safe to remove the plug from the pipe you think to get a clearer view? Thanks for your reply btw.
 

·
Registered
Joined
·
185 Posts
They do not appear to be bent. But that could be due to the angle at which im viewing the plug. They are definitely not recessed though. The plug is welded to one of the head pipes with plastic. Would it be safe to remove the plug from the pipe you think to get a clearer view? Thanks for your reply btw.
That's quite likely the problem.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top