Ducati.org forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
I am checking valves on 1098.I do have vertical cylinder at TDC but cams lobes are not pointing strait up.
 

Attachments

·
Registered
Joined
·
2,127 Posts
Ohh that's ok, everything looks fine to me. Go ahead and make the measurements! :)
 

·
Registered
Joined
·
50 Posts
Discussion Starter · #3 ·
Do I take measurements at TDC or should I rotate engine little so cam lobes are pointing up?

Thank you.
 

·
Registered
Joined
·
2,127 Posts
As long as the lobes are not pushing down on the valves, you're fine. In this case, the lobes are pointed up and out of the way, so measure and you'll be A-OK. :)
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top