Ducati.org forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
Looking for specifically 999RS Wide axle cush rubber/Sprocket carrier and wheel spacers to fit 16.5" Marchesini.
These are the last few parts I need to finish my project. Any leads will be appreciated!

[email protected]
 

·
Registered
Joined
·
43 Posts
I have one of the sprocket carriers. I need it for my own project but I could make a new one and sell you my unused one. But that wouldn't be cheap. Here is the OEM part number you might be able to find one online still.

160.1.243.1A

Just checked and Ducati Omaha lists them for $330. That's cheaper than I could make a one-off for myself for so I'd recommend them...



 

·
Registered
Joined
·
81 Posts
Discussion Starter · #3 ·
Thanks I believe I have everything now
 

·
Registered
Joined
·
43 Posts
Have you been able to source the cush drive pins?

I've come up with a temporary solution out of a steel M10 hex head cap screw but the head is a few millimeters too short and I am not a fan of using it long term.

If I am unable to find them I may just make a set.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top