Ducati.org forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
263 Posts
Discussion Starter · #1 ·
I took the clutch slave off of my 916 and tried to put it on the 1098 and it won't fit on. I push it up on the rod but it will only go so far. It won't go all the way on. Is there a difference between the 916 and 1098? It was working fine on the 916.
 

· Registered
Joined
·
305 Posts
Sure is, different rod lenghts

I have listed a few on ebay here is the item number for one and just use it to check out the other colors item# 260112536936

http://cgi.ebay.com.au/DUCATI-1098-...yZ102691QQrdZ1QQcmdZViewItem#ebayphotohosting

Dual O-Ring, billet CNC different anodized finishes

There is a picture with the instructions attached which will help you identify what slave unit you have. I include a spacer kit so it can be used on any model

Hope the picture helps clarify why yours wont fit

Cheers
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top